ESP32 vs ESP32-S3: which board should you buy?

Both chips come from Espressif, both have Wi-Fi, and both run the same Arduino and ESP-IDF tooling. So why do two families exist, and which one belongs on your bench? This guide keeps it practical.
The short answer
- Pick the original ESP32 for general projects: sensors, web servers, MQTT nodes, home automation, classic Bluetooth audio. It is well documented, has a huge community and is usually the cheaper board.
- Pick the ESP32-S3 when you need native USB, more GPIO, a camera or display, or on-device machine learning.
What is different
| ESP32 | ESP32-S3 | |
|---|---|---|
| CPU | Dual-core Xtensa LX6, up to 240 MHz | Dual-core Xtensa LX7, up to 240 MHz |
| Wi-Fi | 802.11 b/g/n | 802.11 b/g/n |
| Bluetooth | Classic (BR/EDR) and Low Energy | Bluetooth 5 Low Energy only |
| USB | Needs a USB-to-serial chip on the board | Native USB (OTG), no bridge chip needed |
| AI / signal processing | No vector instructions | Vector instructions that speed up neural network and DSP code |
| GPIO | Up to about 34 usable pins | Up to about 45 pins |
The exact numbers depend on the module on your board, so always check the datasheet of the board you buy.
Native USB is the big one
On a classic ESP32 board, a small chip (often a CP210x or CH340) converts USB to serial. That works well for flashing and logging, but the ESP32 itself cannot act as a USB keyboard, mouse or storage device.
The ESP32-S3 has USB built in. That lets it appear as a keyboard, a MIDI device or a drive, and it can also work as a USB host. If your project talks to USB devices, the S3 is the natural choice. If you only need to flash and print debug output, the original is fine.
Bluetooth: classic or not?
If you want to stream audio to a speaker over Bluetooth (A2DP) or use classic Bluetooth serial, you need the original ESP32. The S3 supports Bluetooth Low Energy only, which is perfect for phones, beacons and sensors, but not for classic profiles.
Machine learning and cameras
The S3's vector instructions make small neural networks, wake-word detection and image tasks noticeably faster. It is the better base for camera projects and for TinyML experiments.
Which pack size?
Prototyping usually starts with one board. But ESP32 boards tend to end up inside things: a sensor in the garage, one in the greenhouse, one on the desk. Packs of 3 and 5 cost less per board, so buy a pack once you know the design works.
Our recommendation
Start with the original ESP32 for learning and everyday automation. Move to the ESP32-S3 when your project needs USB, a camera or on-device AI.