Blog
Guides and tips for ESP32 boards, USB hubs and your next build.
3 min readESP32 with Arduino IDE: install the board package and run your first sketch
Set up ESP32 in Arduino IDE 2: add the Espressif board URL, install the package, pick the board and port, upload a blink sketch and fix common errors.
Read article →
4 min readESP32 deep sleep: how to run a sensor on a battery for months
How ESP32 deep sleep works, with an Arduino timer wake-up and a full ESPHome example. What stays powered, what is lost and what drains your battery.
Read article →
4 min readESP32 pinout: which GPIO pins to use, and which to avoid
A practical ESP32 GPIO guide. Safe pins for your first projects, strapping pins, input-only pins, ADC2 and Wi-Fi, flash pins, plus what changes on the ESP32-S3.
Read article →
4 min readESP32-S3 N16R8 explained: 16 MB flash, 8 MB PSRAM and the pins you lose
What N16R8 means on an ESP32-S3 board, when 8 MB of octal PSRAM is worth it, which pins are taken (GPIO35 to 37) and how to set up Arduino and ESPHome.
Read article →
3 min readESPHome Bluetooth proxy: extend Home Assistant's Bluetooth range with an ESP32
Turn an ESP32 into a Bluetooth proxy for Home Assistant with ESPHome. Full YAML, active connections, placement tips and proxy vs presence sensor.
Read article →
3 min readESPHome tutorial: DHT22 temperature and humidity sensor with an ESP32
Wire a DHT22 to an ESP32, write the ESPHome YAML, flash over USB and send temperature and humidity to Home Assistant. Pull-up and calibration tips.
Read article →
3 min readESPHome tutorial: connect an ESP32 to a Bluetooth device (BLE client)
Learn the difference between listening and connecting in Bluetooth Low Energy, then connect an ESP32 to a BLE device with ESPHome and read its battery level.
Read article →
3 min readESPHome tutorial: Bluetooth presence detector with an ESP32
Detect who is home with an ESP32 and ESPHome: BLE presence for tags and phones, signal strength by room, a nearby-devices scanner and privacy limits.
Read article →
4 min readESPHome tutorial: monitor your home temperature with an ESP32 and a Xiaomi Mijia
Turn a 4-euro Xiaomi Mijia thermometer and an ESP32 into a local temperature and humidity monitor. ESPHome YAML, bindkey, flashing and Home Assistant.
Read article →
2 min readESP32 vs ESP32-S3: which board should you buy?
A practical comparison of the original ESP32 and the ESP32-S3: USB, Bluetooth, AI features, GPIO count and which one fits your project.
Read article →
2 min readESP32 first steps: a checklist for your new dev board
Upload fails? Board not detected? A short checklist for the first hour with an ESP32: cables, drivers, boot mode, voltage and pins to avoid.
Read article →